What Tankless Needs That a Tank Does Not
A tankless unit fires at a much higher burner rating than a tank, so the gas line often needs to be larger. Many also need stainless or PVC venting through a wall or roof, a condensate drain and an electrical outlet.
We check the gas meter capacity, line size and vent path before we quote, so you do not discover a surprise on installation day.
| Question | Tank | Tankless |
|---|---|---|
| Hot water supply | Limited by tank size | Continuous at the rated flow |
| Space | Floor footprint | Wall mounted |
| Gas line | Usually existing | Often upsized |
| Maintenance | Annual drain | Annual descale flush |
| Typical lifespan | 10 to 15 years | 15 to 20 years with care |
Flush and Descale: Why Chaska Water Makes It Important
The 2025 City of Chaska drinking water report lists the water at 26 grains per gallon, which is hard. Mineral scale builds inside a tankless heat exchanger, narrows the passages and triggers error codes or lukewarm water.
A descale flush circulates a mild acid solution through the unit to dissolve scale. Most manufacturers call for it at least once a year, and in hard water, more often is wise.
Shut off and isolate
We close the gas and water isolation valves and connect hoses to the service ports.
Circulate the solution
A pump circulates a descaling solution through the heat exchanger for the time the manufacturer specifies.
Flush and inspect
We rinse the unit, clean the inlet screen, check for leaks and read the error history.
Repairs: Error Codes, Cold Sandwich and Ignition
Error code on the display
Scale, a clogged inlet screen, a failed flow sensor or an exhaust issue. The code narrows it down.
Water goes cold, then hot
The unit shuts off at low flow. A scaled heat exchanger or a clogged screen can cause it.
No ignition
A failed igniter, a gas supply issue or a blocked vent. We test each in order.
Tankless problem or planning an install?
Call and give us the brand and model if you have it. We will tell you whether it sounds like service or a new install.
Tankless Water Heater Cost
Tankless units and installs run higher than standard tanks, commonly $2,500 to $6,000 or more installed in typical US pricing. A descale flush is a much smaller job. The price depends on:
Tankless installs are usually planned work and not covered by insurance. A sudden failure of an existing unit may fall under your policy.
Permits for Tankless Installs in Chaska
A tankless installation counts as a water heater replacement or installation, and the City of Chaska requires a plumbing permit for that work. Gas line changes and venting are part of the permitted scope.
We handle the permit and schedule the inspection through the City's inspections office.
Source: City of Chaska plumbing permit information.
Tankless Water Heater Questions in Chaska
We take after-hours calls for no-hot-water problems with all water heater types, including tankless. We cannot promise a fixed arrival time, but we can help you with safe shutoff while we dispatch.
At least once a year, and more often in hard water. Chaska's water is reported at 26 grains per gallon, so annual descaling is the minimum we suggest.
Yes. A softener removes the minerals that form scale, which protects the heat exchanger. We can size one for your household. See water softener installation.
It can be if you value space, endless hot water and a long lifespan. The savings depend on gas rates and use. We walk you through the numbers rather than promising a payback.
Yes, but electric units draw a lot of power and often need a dedicated high-amp circuit. Many Minnesota homes are better served by gas or heat pump models.
It depends on the brand, but common causes are scale, a dirty inlet screen, a flow sensor fault or a blocked vent. Read us the code and we will tell you what it usually means.
